Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 196

do
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
do
Use the do command to execute an EXEC-level show command from any configuration mode or
submode.
Syntax Description command
Defaults
None.
Command Modes All configuration modes.
Command History Release
1.1(1)
Usage Guidelines
Use this command to execute EXEC level show commands while configuring your switch. After the
EXEC command is executed, the system returns to the mode from which you issued the do command.
Examples
The following example displays the information about the cluster tape details in the Cisco SME tape
volume configuration submode:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# tape-bkgrp group1
switch(config-sme-cl-tape-bkgrp)# tape-device devicename1
switch(config-sme-cl-tape-bkgrp-tapedevice)#do show sme cluster clustername1 tape detail
Tape t1 is online
The following example displays the counters in the interface in the Cisco SME crypto tape volume group
configuration submode:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# tape-bkgrp group1
switch(config-sme-cl-tape-bkgrp)# tape-volgrp t1
switch(config-sme-cl-tape-bkgrp-volgrp)#do show interface sme 3/1 description
sme3/1
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
A-8
do command
Specifies the EXEC command to be executed.
Modification
This command was introduced.
Is a Tape Drive
Model is HP Ultrium 2-SCSI
Serial Number is HUM4A00184
Is configured as tape device b1 in tape group b1
Paths
Host 12:01:00:e0:8b:a2:08:90 Target 52:06:0b:11:00:20:4c:4c LUN 0x0000
Is online
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0.00 KB/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0.00 KB/sec
Appendix A Cisco SME CLI Commands
OL-18091-01, Cisco MDS NX-OS Release 4.x