Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 209

Appendix A Cisco SME CLI Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
load-balancing
To enable cluster load balancing for all targets or specific targets, use the load-balancing command. To
disable this command, use the no form of the command.
Syntax Description
enable
target wwn
Defaults None.
Command Modes
Cisco SME cluster configuration submode.
Command History Release
3.3(1c)
Usage Guidelines The load-balancing operation is performed by the Cisco SME administrator for all or specific target
ports. This operation first unbinds all the targets from the Cisco SME interfaces. The targets are then
associated, one at a time, based on the load-balancing algorithm. For more information on the load-
balancing algorithm, see
The load-balancing operation can be triggered if the targets remain unconnected due to errors in the prior
load-balancing operations in the backend.
Examples The following example enables reload balancing in Cisco SME:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# load-balancing enable
switch(config-sme-cl-node)#
The following example adds the host to the Cisco SME interface based on the load-balancing policy:
switch# config t
switch(config))# sme cluster c1
switch(config-sme-cl)# load-balancing 17:11:34:44:44:12:14:10
switch(config-sme-cl-node)#
Related Commands Command
show sme cluster
OL-18091-01, Cisco MDS NX-OS Release 4.x
load-balancing {enable | target wwn}
no load-balancing {enable | target wwn}
Enables cluster load balancing.
Specifies the worldwide name (WWN) of the target port.
Modification
This command was introduced.
Chapter 1, "Product Overview."
Description
Displays Cisco SME information.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
load-balancing
A-21