Configuring Unique Or Shared Key Mode; Enabling And Disabling Automatic Volume Groups - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Cisco mds 9000 family storage media encryption configuration guide - release 4.x (ol-18091-01, february 2009)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Configuring Unique or Shared Key Mode

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 3
switch(config-sme-cl)# fabric
clustername1
Step 4
switch(config-sme-cl)# node
A.B.C.D|X:X::X|DNS name
switch(config-sme-cl-node)#
Step 5
switch(config-sme-cl-node)#
fabric-membership clustername1
Step 6
switch(config-sme-cl-node)#
interface sme 3/1 force
Configuring Unique or Shared Key Mode
Shared key mode is used to generate a single key that is used for a group of backup tapes.
Unique key mode is used to generate unique or specific keys for each tape cartridge.
To configure the shared key or unique key mode, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Step 3
switch(config-sme-cl)# shared-key
mode
switch(config-sme-cl)#
Step 4
switch(config-sme-cl)# no shared-key
mode
switch(config-sme-cl)#
Note
Configure the Cisco KMC before configuring the key mode. See the
section on page

Enabling and Disabling Automatic Volume Groups

When SME recognizes that a tape barcode does not belong to an exiting volume group, then SME creates
a new volume group when automatic volume grouping is enabled.
Automatic volume grouping is disabled by default.
To enable or disable automatic volume grouping, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
7-6
6-2.
Chapter 7
Using the Command Line Interface to Configure SME
Purpose
Specifies the fabric.
Enters the SME cluster node submode and specifies a
remote switch. The format is A.B.C.D | X:X::X | DNS
name.
Specifies the fabric membership for the cluster.
Adds the SME interface (3/1) from a remote switch in
fabric f2.
Purpose
Enters configuration mode.
Specifies the cluster and enters SME cluster configuration
submode.
Specifies shared key mode.
Specifies shared unique key mode.
"Cisco Key Management Center"
Purpose
Enters configuration mode.
Specifies the cluster and enters SME cluster configuration
submode.
OL-18091-01, Cisco MDS NX-OS Release 4.x

Advertisement

Table of Contents
loading

Table of Contents