Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 199

Appendix A Cisco SME CLI Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fabric-membership
To add a node to a fabric, use the fabric-membership command. To remove the node from the fabric,
use the no form of the command.
Syntax Description
fabric name
Defaults None.
Command Modes Cisco SME cluster node configuration submode.
Command History Release
3.2(2c)
Usage Guidelines Use the fabric-membership command to put a node in a fabric.
This command has to be configured before the interface sme slot/port [force] command can be
accepted. The command cannot be removed if the interface sme slot/port [force] command is enabled.
Examples The following example specifies a fabric to which the node belongs:
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# node local
switch(config-sme-cl-node)# fabric-membership f1
Related Commands Command
interface sme
show interface sme
shutdown
OL-18091-01, Cisco MDS NX-OS Release 4.x
fabric-membership fabric name
no fabric-membership fabric name
Specifies the fabric name. The maximum length is 32 characters.
Modification
This command was introduced.
Description
Configures the Cisco SME interface to a cluster.
Displays interface information.
Enables or disables an interface.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
fabric-membership
A-11