HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 282

To delete a member from the ACL:
Connect to the switch and log in as admin.
1.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the select prompt, enter 3 to delete a member based on its port/node WWN.
4. At the prompt, enter the WWN of the member to be deleted from the ACL.
5. At the prompt, enter 1 to display the access list so you can verify that the WWN you entered was
deleted from the ACL.
6. After verifying that the WWN was deleted correctly, enter 0 at the prompt to end the session.
At the "Update the FLASH?" prompt, enter y.
7.
8. Press Enter to update the nonvolatile memory and end the session.
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 3
Port/Node WWN (in hex): [00:00:00:00:00:00:00:00] 20:00:00:20:37:65:ce:aa
*WWN is successfully deleted from the MS ACL.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [2] 1
MS Access List consists of (13): {
20:00:00:20:37:65:ce:aa
20:00:00:20:37:65:ce:bb
20:00:00:20:37:65:ce:ff
20:00:00:20:37:65:ce:11
20:00:00:20:37:65:ce:22
20:00:00:20:37:65:ce:33
10:00:00:60:69:04:11:24
10:00:00:60:69:04:11:23
21:00:00:e0:8b:04:70:3b
10:00:00:60:69:04:11:33
20:00:00:20:37:65:ce:55
20:00:00:20:37:65:ce:66
}
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 0
done ...
Update the FLASH?
*Successfully saved the MS ACL to the flash.
switch:admin>
282 Configuring the Distributed Management Server
(yes, y, no, n): [yes] y