HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 406

Do you want to save Defined zoning configuration only? (yes, y, no, n):
[no] y
To clear changes to a configuration:
1. Enter the cfgTransAbort command.
When this command is executed, all changes since the last save operation (performed with the
cfgSave command) are cleared.
In the following example, assume that the removal of a member from zone1 was done in error:
switch:admin> zoneremove "zone1","3,5"
switch:admin> cfgtransabort
To view all zone configuration information:
If you do not specify an operand when executing the cfgShow command to view zone configurations,
then all zone configuration information (both defined and effective) displays. If there is an outstanding
transaction, then the newly edited zone configuration that has not yet been saved is displayed. If there are
no outstanding transactions, then the committed zone configuration displays.
1. Connect to the switch and log in as admin.
Enter the cfgShow command with no operands.
2.
switch:admin> cfgshow
Defined configuration:
cfg:
cfg:
zone:
1,1; array1; 1,2; array2
zone:
1,0; loop1
alias: array1
alias: array2
alias: loop1
Effective configuration:
cfg:
zone:
zone:
To view selected zone configuration information:
1. Connect to the switch and log in as admin.
2. Enter the cfgShow command and specify a pattern.
cfgshow "pattern"[, mode]
The values represent the following:
pattern
mode
406 Administering Advanced Zoning
USA1 Blue_zone
USA_cfg Red_zone; Blue_zone
Blue_zone
Red_zone
21:00:00:20:37:0c:76:8c; 21:00:00:20:37:0c:71:02
21:00:00:20:37:0c:76:22; 21:00:00:20:37:0c:76:28
21:00:00:20:37:0c:76:85; 21:00:00:20:37:0c:71:df
USA_cfg
Blue_zone
1,1
21:00:00:20:37:0c:76:8c
21:00:00:20:37:0c:71:02
1,2
21:00:00:20:37:0c:76:22
21:00:00:20:37:0c:76:28
Red_zone
1,0
21:00:00:20:37:0c:76:85
21:00:00:20:37:0c:71:df
A POSIX-style regular expression used to match zone configuration names.
Specify 0 to display the contents of the transaction buffer (the contents of
the current transaction), or specify 1 to display the contents of the
nonvolatile memory. The default value is 0.