Enabling Persistently Disabled Ports - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual
Hp storageworks fabric os 6.x administrator guide (5697-0015, may 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- Hardware reference manual (256 pages) ,
- User manual (248 pages)
Table of Contents
Advertisement
Enabling persistently disabled ports
Before an FCIP tunnel can be used, the associated ports must be persistently enabled.
NOTE:
VEX_Port Users: If the fabric is already connected, you must leave the ge0 and ge1 ports disabled
until after you have configured the VEX_Port; this will prevent unintentional merging of the two fabrics.
To enable a persistently disabled port:
1.
Enter the portCfgShow command to view ports that are persistently disabled.
2.
After identifying the ports, enter the portCfgPersistentEnable command to enable the ports.
440 Configuring and monitoring FCIP extension services
Advertisement
Table of Contents
Troubleshooting
