HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 253
Hp storageworks fabric os 6.x administrator guide (5697-0015, may 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- Hardware reference manual (256 pages) ,
- User manual (248 pages)
Table of Contents
Advertisement
To add devices that are connected to the Brocade fabric, click Edit in the Pending Zone set.
6.
7.
On the Modify Zone tab, enter the device WWN into the World Wide Name field and click Add.
The Pending Zone Membership List is updated with the new Zone members.
If you are using EFCM, select Potential Zone Members > New Member, enter the WWN port
name, and click Add.
NOTE:
The procedures described in this section were current when the document was written, but may
have changed since then. Refer to the Zoning User Manual available per the HP switch product web page.
Select the Zone Set tab in SAN Pilot.
8.
If you are using EFCM or the Zoneset Library window, tab to Zone Sets and select File > New.
9.
Enter a name for the Pending Zone set in Zone Set Name and select Rename.
The steps for EFCM will be similar.
Click Save and Activate the Pending Zone set.
10.
The zones in the Pending Zone set are added to the Zone Set that you specified.
In EFCM, return to the main window and select Configure, then select Activate Zone Set to launch
the zone set activation window. Highlight the zone set to be activated and click Next. Click Next
again, then Start to activate the zone set.
Fabric OS 6.x administrator guide 253
Advertisement
Table of Contents
Troubleshooting
