Sulb-1035; Sulb-1037 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual
Brocade error message reference guide v6.0.0 (53-1000600-01, april 2008)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Reference (550 pages)
Table of Contents
Advertisement
86
SULB-1035
Recommended
Reboot the switch. This will cause the internal image to be relocated again. Use the
Action
firmwareDownloadStatus to monitor the progress. If the problem persists, contact your switch
service provider.
Severity
ERROR
SULB-1035
Message
AUDIT, <timestamp>, [SULB-1035], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , An error has occurred relocation of the internal image.
Probable Cause
Indicates that an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended
Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
Action
contact your switch service provider.
Severity
ERROR
SULB-1037
Message
AUDIT, <timestamp>, [SULB-1037], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , HCL failed. Reboot the switch manually using the reboot
command. However, it will disrupt the FC traffic.
Probable Cause
Many reasons can cause HCL to fail, such as domain not confirmed.
Recommended
Run the reboot command to reboot the switch manually.
Action
Severity
Error
528
Fabric OS Message Reference
53-1000600-01
Advertisement
Table of Contents
