Fw-1140; Fw-1160; Fw-1161 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual
Brocade error message reference guide v6.0.0 (53-1000600-01, april 2008)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Reference (550 pages)
Table of Contents
Advertisement
29
FW-1140
FW-1140
Message
<timestamp>, [FW-1140], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause
Indicates that the number of small form-factor pluggable (SFP) state changes has changed from a
value outside of the acceptable range to a value within the acceptable range. SFP state changes
occur when the SFP is inserted or removed.
Recommended
No action is required. Respond to this message as is appropriate to the particular policy of the
Action
end-user installation.
Severity
INFO
FW-1160
Message
<timestamp>, [FW-1160], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, value has changed(High=<High value>, Low=<Low value>). Current value is
<Value> <Unit>.
Probable Cause
Indicates that the number of link failures that the port experiences has changed. Link loss errors
occur when a link experiences a loss of signal and fails. Both physical and hardware problems can
cause link loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for
concurrent loss of synchronization errors and, if applicable, troubleshoot them.
Recommended
Check both ends of your cable connection. Verify that the cable and small form-factor pluggables
Action
(SFPs) are not faulty.
Losses of synchronization commonly causes link failures. If you receive concurrent loss of
synchronization errors, troubleshoot the loss of synchronization.
Severity
INFO
FW-1161
Message
<timestamp>, [FW-1161], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause
Indicates that the number of link failures that the port experiences has fallen below the low
boundary. Link loss errors occur when a link experiences a loss of signal and fails. Both physical
and hardware problems can cause link loss errors. Link loss errors frequently occur due to a loss of
synchronization. Check for concurrent loss of synchronization errors and, if applicable,
troubleshoot them. A low number of link loss errors means that the switch is functioning normally.
Recommended
No action is required. Respond to this message as is appropriate to the particular policy of the
Action
end-user installation.
Severity
INFO
188
Fabric OS Message Reference
53-1000600-01
Advertisement
Table of Contents
