Em-1062; Em-1063; Em-1064 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

12

EM-1062

Recommended Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is
Action taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the
system will remain out of synchronization.
Severity WARNING
EM-1062
Message
<timestamp>, [EM-1062], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <Slot Id> faulted as it exceeds the maximum support limit of <Limit> blades
with Blade ID <Blade Type Id> in the chassis.
Probable Cause Too many blades of a particular type are in the system.
Recommended Remove the faulted blade.
Action
Severity CRITICAL

EM-1063

Message
<timestamp>, [EM-1063], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <Slot Id> faulted because it exceeds the maximum support limit of <Limit>
blades with Blade IDs <Applicable blade Type IDs> in the chassis.
Probable Cause Too many blades of a set of particular types are in the system.
Recommended Remove the faulted blade.
Action
Severity CRITICAL

EM-1064

Message
<timestamp>, [EM-1064], <sequence-number>,, CRITICAL, <system-name>, Blade:<slot
ID> is being powered off (based on user configuration) upon receiving a HW ASIC
ERROR, reason:<Fault reason>.
Probable Cause The blade is power off since a hardware (HW) application specific integrated circuit (ASIC) ERROR
was detected, and the user has selected to power off the problem blade when such a condition
occurred.
Recommended Contact support.
Action
Severity CRITICAL
92 Fabric OS Message Reference
53-1000600-01