Installing a hot-swap power supply
This procedure applies only to server models that have hot-swap power supplies.
See "Installing a non-hot-swap power supply" on page 107 for information about the
installation of a non-hot-swap power supply.
To install a hot-swap power supply, complete the following steps:
1. Place the power supply into the bay guides.
2. Using the handle, push the power supply toward the front of the chassis until it
3. Connect one end of the power cord into the connector on the back of the power
4. Make sure that both the ac and dc power LEDs on the rear of the power supply
74
System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
Release lever
Hot-swap power
supply
locks into place.
supply and connect the other end of the power cord into a properly grounded
electrical outlet.
are lit, indicating that the power supply is operating correctly.