Rear View - IBM 436854u - System x3200 M2 5U Mini Tower Server Problem Determination And Service Manual

Rear view

The following illustration shows the connectors and LEDs on the rear of the server.
Serial 2 (Com2)
Serial 1 (Com1)
Power-cord connector
AC power LED
DC power LED
Serial 2 connector
Parallel connector
Serial 1 connector
Video connector
USB connectors
Ethernet connector
Ethernet transmit/receive activity LED
6
System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
Power cord
AC power LED
DC power LED
Parallel
Video
USB 3 and 4
Ethernet
connector
USB 1 and 2
Remote
Supervisor
Adapter II
SlimLine
(Ethernet)
Connect the power cord to this connector.
On some server models, each hot-swap power supply has an ac power
LED and a dc power LED. During typical operation, both the ac and dc
power LEDs are lit.
On some server models, each hot-swap power supply has a dc power LED
and an ac power LED. During typical operation, both the ac and dc power
LEDs are lit.
Connect a 9-pin serial device to this connector.
Connect a parallel device to this connector.
Connect a 9-pin serial device to this connector.
Connect a monitor to this connector.
Connect USB devices to these connectors.
Use this connector to connect the server to a network.
This LED is on the Ethernet connector on the rear of the server. When this
LED is lit, it indicates that there is activity between the server and the
network.
Ethernet transmit/
receive activity LED
(amber)
Ethernet link
status LED
(green)