HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 83

13. Remove the filler panel covering the tape drive slot at the front of
the server (illustrated below), using a Torx #15 driver to remove
the two screws. Reserve the screws for attaching the tape drive.
Keep the filler panel. To properly operate the server in the
CAUTION!
future without a tape drive in the slot, the slot must again be
covered with the filler panel.
14. Insert the tape drive module (consisting of the tape drive in its
tray) into the uncovered tape drive slot at the front of the server.
The tray must fit between two sheet metal guides at both sides
of the enclosure. If the tray does not slide easily, it may not be
inside the guides. When the tray is fully inserted, its front holes
align with the holes in the metal front of the enclosure.
Remove
screws
here.
Slide tray
between
sheet metal
guides.
Adding a Tape Drive 8
-
5