HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 27

Optional: Additional
Control Panel Changes:
Password,
Auto-Restart,
Link Speed
No Further Control
Panel Changes
9. Refer to the table on page 3-6 for any setup changes you want to
make on the control panel. Examples of setup changes are:
• You may set a password to limit access to the control panel.
Set the
• You may want the server to automatically attempt to
restart following critical errors rather than halt and wait.
Set the
• If you must set a specific link speed or duplex mode, rather
than have them set automatically, set the
parameter.
Scroll to the desired control panel parameter. Use the following
buttons (as indicated by the scroll symbol  in the top line of
the display):
to scroll "down" to the next parameter in the list
to scroll "up" to the previous parameter in the list
To select the parameter for modification, press
scroll symbol  is in the first line of the display).
Use the and
settings (when the scroll symbol  or flashing characters are in
the second line of the display) or to edit characters in the
setting. Press
(A table listing the behavior of all the buttons is in "Control
Panel Reference" on page 3-1.)
10. Exit the control panel setup mode to proceed with server
initialization. Press
Press to confirm the exit.
Note: If your IP address, subnet mask, and gateway
settings (done in steps 6, 7, and 8 above) are inconsistent
when you attempt to exit, the error message shown below
displays for three seconds.
In response, press
one of the three addressing parameters to correct the
inconsistency (see page 2-9). If you do exit without
correcting the error, the server may be inaccessible on the
network.
parameter.
parameter.
buttons to scroll through the choices of
to accept the setting.
to cancel; The following displays:
e ?
o
or wait for three seconds. Return to
(when the
-
Installation 2 11