Reset to
Once the server has been installed, its configuration can be changed
by using the control panel during initialization or by using
"First Time"
HD Server Admin after initialization. But if your changes produce
Defaults
errors so serious that you cannot succeed in changing back to a
Procedure
working configuration, then you can return to the networking
configuration for the first-time installation by using this procedure.
You may also need this procedure if you redeploy the server (and
you may need to recreate the volume, per page 4-9).
This operation does not affect the file system. It does not change the
current configuration of the volume, shares, users, groups, and
backup schedule.
This procedure must be done from the initialization state, at the
control panel, as follows:
1. Restart the server. When the control panel displays
2. Use the
3. When prompted
4. When prompted
5. Wait 10 seconds for the disk drives to stop spinning. Then switch
The resulting default settings are described in the following table.
, press
When prompted
button to scroll to the
press
.
switch to switch power off.
on the power switch. Follow the initialization process starting at
step 4 on page 2-8—as if you are installing a server for the first
time.
before the countdown completes.
, press
again.
Shutting Down and Restarting 6
parameter and
, press
.
, press the power
-
7