Accessing Control Panel Parameters; View Mode; Setup Mode - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

View Mode

Setup Mode

-
3 2 Configuration Using the Control Panel

Accessing Control Panel Parameters

The primary modes for using control panel parameters are
view mode, available from the normal operating state, and
setup mode, available from the initialization state (see page 6-10).
(Boot mode has special uses for product code; see page 10-3.)
You can use view mode for viewing the current settings, for reading
any alerts, for checking the link type, for changing the control panel
password, and for shutting down the server. While the server is
operating normally, you enter view mode by pressing the
on the control panel.
You will be prompted for the control panel password—if you have
set one. In that case, see "Supplying the Password for Access" on
page 3-3, and then return here.
The control panel display then alternates the following instructions
for entering view mode:
Ç È
Press any control panel button to proceed in view mode or wait
about 30 seconds. The settings are listed in the table on page 3-6.
For procedures that use the control panel, refer to the following:
•
For shutdown see chapter 6, "Shutting Down and Restarting".
•
To check errors and alerts see chapter 11, "Resolving Problems
with Your Server".
Enter setup mode to make changes to the server's settings.
•
This happens automatically when installing the server for the
first time (see chapter 2) if you choose the manual method of IP
address setting. Proceed to page 2-9 for additional setup
procedures.
•
After installing the server for the first time, you can get into
setup mode whenever you restart the server. During
initialization the control panel displays the following
countdown from 10 to 0 seconds for entering setup mode.
If you do not press
completed, then startup will resume.
before the countdown of 10 seconds is
button