7. Detach the next connection behind the removed RJ-45
connector—the power cable. (See the illustration below.)
Now the server is fully detached.
Detach
power
cable
8. Push the server module from the inside rear and receive it from
the front of the enclosure with your other hand beneath the
module. Support the module with your whole hand; do not pull on
the front plastic panel.
9. Make sure that the new server is installed in its metal tray in the
same way as the old one.
10. Insert the new server module into the server slot at the front of
the server. The tray must fit between two sheet metal guides at
both sides of the enclosure. If the tray does not slide easily, it may
not be inside the guides. When the tray is fully inserted, its front
holes align with the holes in the metal front of the enclosure.
Slide tray
between
sheet metal
guides
Resolving Problems with Your Server 11
-
33