Adding Modules; Rack Mounting - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Optional: Adding Modules
Installing Hard
Drive Modules
Installing
Internal Tape
Drive Module
Attaching
External Tape
Drive
Note
Optional: Rack Mounting
Use this section if you intend to add components to the
HP SureStore HD Server 4000 before you install it.
The product numbers HP J3290A and J3291A have empty slots
accommodating up to three additional HP hard disk drive modules.
These drives can be used to expand the volume. (One of the additional
modules can be reserved as a hot spare.) Refer to chapter 7 for a list of
drive products available and the instructions for installation; then
return to this page to complete the server installation.
You may add an internal tape drive to any of the three product
numbers. (HP J3291A has a DAT40 drive already installed.) Refer to
chapter 8 for a list of tape drive products available and the
instructions for installation; then return to this page to complete
the server installation.
You may attach one external HP DAT or HP DLT drive to any
HD Server 4000. You may install both an external and an internal
tape drive. Refer to chapter 8 for a list of the tape products available
and the instructions for attachment; then return to this page to
complete the server installation.
The external tape drive attaches to the HD Server in place of
the preinstalled SCSI terminator. Ensure that a SCSI
terminator is attached to the end of the SCSI bus, usually on
the external tape drive. The terminator you remove from the
HD Server's SCSI connector (HP part no. 5063-5324) may be
moved to the tape drive. Otherwise, you may use the SCSI
terminator block attached to the rear of the tape drive.
After you have installed any additional modules (as described in the
previous section), you can use the HP J1492B Rackmount Kit for
HP Storage System/6 to mount the server in any HP 19-inch rack.
Perform the rack mounting before attaching power or cables to the
HD Server.
-
Installation 2 5