-
11
24 Resolving Problems with Your Server
6. On the new drive module, press the locking tab down while you
pull the drive lever out and fully up. The locking pin on the top of
the drive fully retracts to allow insertion into the slot.
Unlocking the
new drive
7. Holding the module only by its plastic front bezel and the metal
tray, slide the module slowly into the slot until it stops, at the end
of the drive lever. The module remains extended about 5 mm or
0.2 inches from the adjacent surfaces in this position. See the
illustration below.
With drive lever pulled
out, sliding the module
into slot until it stops
Locking pin