Restart; Power Cycle - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Restart

Note

Power Cycle

CAUTION!
-
11 18 Resolving Problems with Your Server
Restarting interrupts client sessions briefly, reapplies the settings
in the server configuration stored in Flash memory, and runs
initialization self-tests. First notify users that the server will be off
line and recommend they close all files.
You can use either (a) the control panel on the front of the server or
(b) HD Server Admin using a web browser at another computer on
the network.
a. At the control panel, first perform the shutdown procedure
(step 2a above on page 11-17). At the following display on the
control panel, press
b. Access HD Server Admin. (Instructions start on page 4-1.
A username and password may be required.) Use the
Configuration Æ Shutdown/Restart page. Click Shutdown
and Restart and [Apply].
After restarting, the server performs the initialization process,
described starting at step 3 in "Startup Steps" on page 6-1.
From fault conditions that halt or freeze the server, it will
automatically restart if the Automatic Restart parameter is
enabled. If the parameter is disabled (as it is by default) or
auto-restart has occurred three times, then the server merely
shuts down.
Use the power cycle procedure only when necessary to:
•
Replace failed components.
•
Move the server to another physical location or network location
(that is, to connect a network cable).
•
Restart the server when normal restart procedures (see
page 11-18 above) have failed.
•
When recommended as part of another procedure.
Switching the server's power off without following the
appropriate shutdown procedure can result in lost user data.
Always make sure it is safe to cycle the power before doing so.
Alert users that the server will be off line (inaccessible) while
shut down; then complete the shutdown procedure before
switching off power.
to restart.