HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 85

17. Inside the enclosure, find the unattached connector on the power
cable (not the connector at the end of the cable that is used for the
server module above the tape drive). Attach it to the power
connector to the right of the SCSI connector.
If installing an HP DAT24i tape drive, the power extension
cable found in the tape drive packaging may help you fit the
power cable. See the illustration below.
Server
power
cable
Tape drive
power
connector
or
extender
18. Reinstall the side door by reversing the actions you performed in
step 12 above.
19. Reinstall the front bezel by reversing the actions you performed
in step 11 above.
20. Lock the enclosure keylock if desired to prevent removing
components inside the enclosure.
21. If the server has not yet been installed, go now to the installation
procedure on the Quick Setup guide, or in this manual go to
"Connecting and Starting Up" on page 2-8 and continue with
chapter 2.
22. On the rear of the server, reattach the power cables.
23. On the front of the server, switch on power and verify normal
operation (page 6-4). Notify users that file service is resumed.
24. Refer to chapter 9 for configuration of backup functions.
Tape drives must be cleaned regularly for reliable service.
Note
Follow cleaning instructions in the electronic User's Guide on
the HP SureStore Tape CD-ROM.
Adding a Tape Drive 8
-
7