Installing A Hot-Plug Scsi Hard Disk Drive - HP DL760 - ProLiant - 1 GB RAM User Manual

Installing a Hot-Plug SCSI Hard Disk Drive

CAUTION: Before adding or removing any hot-plug SCSI drives, consult your
operating system instructions. Failure to do so could result in loss of data or damage
to equipment.
To install a hot-plug SCSI hard drive:
1. Remove the blanking panel in an unused drive bay by pushing the side of the
retaining clip inward (1), and then pull the blanking panel outward (2).
Figure 5-12: Removing a hard-drive blanking panel
2. Push the release button on the left of the new drive, and rotate the hot-plug drive
ejector lever outward to unlock the drive.
HP ProLiant DL760 Generation 2 Server User Guide
Installing Hardware Options, Hot-Pluggable
5-29