Pull Tractor Sensor Removal - Epson DFX-8500 Service Manual

DISASSEMBLY AND ASSEMBLY

3.2.6.12 Pull Tractor Sensor Removal

1. Remove the left and right covers. (See Section 3.2.3.2.)
2. Remove the front panel. (See Section 3.2.3.3.)
3. Remove the upper case. (See Section 3.2.3.4.)
4. Remove the printer mechanism. (See Section 3.2.6.)
5. Remove the plunger and paper bail. (See Section 3.2.6.7.)
6. Remove the upper paper guide. (See Section 3.2.6.8)
7. Disconnect the pull tractor sensor connector (red, 2 pins) from the connector junction board.
8. Remove 1 screw (CP (S), M2×14) securing the pull tractor sensor to the left side frame, then remove
the sensor. (See Figure 3-66.)
Screw (CP (S), M2×14)
Washer
Pull Tractor Sensor
Right Platen Holder
Hexagon Nut
Figure 3-66. Pull Tractor Sensor Removal
3-45