Installing The Stand Or Removing The Stand Column; Installing The Stand; Removing The Stand Column; Installing A Wall-Mount Bracket - Dynex DX-L32-10A User Manual

4
Installing the stand or removing
the stand column
Cautions
• Read these instructions carefully before you try to assemble the
stand or remove the stand column.
• Make sure that you handle the TV carefully when attempting to
assemble or remove the stand. If you are not sure of your ability
to do this or to use the tools required, contact a professional
installer or service technician. Dynex is not responsible for any
damages or injuries that occur because of mishandling or
incorrect assembly.
• When using a table or bench as an aid in assembly, make sure
that you use a soft cushion or covering to prevent scratching or
damage to the TV screen or cabinet.
• The speaker is not intended to support the weight of the TV. Do
not move or handle the TV by the speaker. This can cause damage
that is not covered by your warranty.
• Before assembly or removal of the stand, unplug the power cord.
You need to install the TV into the stand to use the TV in an upright
position on a flat surface. For instructions, see "Installing the stand" on
page 4.
If you plan to wall-mount the TV, you need to remove the stand column.
For instructions, see "Removing the stand column" on page 4. If you
wall-mount the TV, use M4*10 screws. This means the diameter is
4 mm and screw thread length is 10 mm.

Installing the stand

You need to install the stand to use the TV in the upright position on a
flat surface.
Note: The appearance of the TV may differ from the illustrations in this
task.
To install the stand:
1 Remove the stand from the box and place it on a table or bench.
2 Lay the TV flat (screen down) on the edge of a table or bench.
Make sure that you put a soft cushion or cloth between the table
or bench and the TV.
Table edge
3 Align the locators on the stand column with the locating holes on
the stand and align the holes in the stand with the holes in the
stand column.
Stand
Stand column

Installing the stand or removing the stand column

4 Secure the stand to the column with the four M5 screws
(provided).
Table edge
5 Carefully lift the TV into the upright position.
To remove the stand, perform these steps in the reverse order.

Removing the stand column

You need to remove the stand column before you wall-mount the TV.
Note: The appearance of the TV may differ from the illustration in this
task.
To remove the stand column:
1 Lay the TV flat (screen down) on the edge of a table or bench.
Make sure that you put a soft cushion or cloth between the table
or bench and the TV.
2 Remove the four screws holding the stand column to the TV, then
remove the stand column.

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand pedestal if it is pre-attached.
To install a wall-mount bracket:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched).
2 Remove the pedestal stand.
3 Remove the stand column. See "Removing the stand column" on
page 4.
4 Secure the wall-mount bracket to the back of your TV using the
four M4*10 screws provided with the bracket.
Stand column