Installing The Stand Or Removing The Stand Column; Installing The Stand; Removing The Stand Column; Installing A Wall-Mount Bracket - Dynex DX-32L151A11 User Manual

4
DX-32L151A11/DX-37L130A11
Installing the stand or removing
the stand column
Cautions
• Read these instructions carefully before you try to assemble the
stand or remove the stand column.
• Make sure that you handle the TV carefully when attempting to
assemble or remove the stand. If you are not sure of your ability
to do this, contact a professional installer or service technician.
Dynex is not responsible for any damages or injuries that occur
because of mishandling or incorrect assembly.
• Use a soft cushion or covering to prevent scratching or damage to
the TV screen or cabinet.
• The speaker is not intended to support the weight of the TV. Do
not move or handle the TV by the speaker. This can cause damage
that is not covered by your warranty.
• Before assembly or removal of the stand, unplug the power cord.
You must install your TV into the stand in order for it to stand upright on
a cabinet or other flat surface. If you intend to mount your TV on a wall
or other vertical surface, you must remove the stand column.

Installing the stand

You must install the stand to use the TV in an upright position on a flat
surface.
Note: Your TV may differ from the illustrations shown.
To install the stand:
1 Remove the stand from the box and place it on a table or bench.
2 Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
Table edge
3 Align the locators on the stand column with the locating holes on
the stand, then secure the stand to the column with the four M5
screws (provided).
Table edge
Stand
Stand column
Locators
Locating holes
Stand
Four M5 screws

Installing the stand or removing the stand column

4 Carefully lift the TV into an upright position.
To remove the stand, perform these steps in reverse order.

Removing the stand column

You must remove the stand column before you can wall-mount the TV.
Note: Your TV may differ from the illustrations shown.
To remove the stand column:
1 Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
2 Remove the four screws holding the stand column to the TV, then
remove the stand column.

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand pedestal, if it is already attached.
To install a wall-mount bracket:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Remove the pedestal stand.
3 Remove the stand column. See "Removing the stand column" on
page 4.
4 Secure the wall-mount bracket to the back of your TV using the
four M6 screws provided with the bracket.

TV components

Accessories

Make sure the following accessories are included in the box with your
TV:
• Remote control
• Composite video & audio cable
• AC power cord
• AAA batteries (2)
• Stand
• Quick Start Guide
Stand column