Installing The Stand Or Removing The Stand Column; Installing The Stand - Dynex DX-L26-10A User Manual

4
Installing the stand or removing
the stand column
Cautions
• Read these instructions carefully before you try to assemble the
stand or remove the stand column.
• Make sure that you handle the TV carefully when attempting to
assemble or remove the stand. If you are not sure of your ability
to do this or to use the tools required, contact a professional
installer or service technician. Dynex is not responsible for any
damages or injuries that occur because of mishandling or
incorrect assembly.
• When using a table or bench as an aid in assembly, make sure
that you use a soft cushion or covering to prevent scratching or
damage to the TV screen or cabinet.
• The speaker is not intended to support the weight of the TV. Do
not move or handle the TV by the speaker. This can cause damage
that is not covered by your warranty.
• Before assembly or removal of the stand, unplug the power cord.
You need to install the TV into the stand to use the TV in an upright
position on a flat surface. For instructions, see "Installing the stand" on
page 4.
If you plan to wall-mount the TV, you need to remove the stand column.
For instructions, see "Removing the stand column" on page 5.

Installing the stand

You need to install the stand to use the TV in the upright position on a
flat surface.
Note: The appearance of the TV may differ from the illustrations in this
task.
To install the stand:
1 Remove the stand from the box and place it on a table or bench.
2 Lay the TV flat (screen down) on the edge of a table or bench.
Make sure that you put a soft cushion or cloth between the table
or bench and the TV.
Table edge
Two locators
Stand column

Installing the stand or removing the stand column

3 Examine the stand carefully. The column socket is not in the
center of the stand. You need to make sure you align the stand
shown in the following illustration.
4 Place the stand close to the end of the stand column and keep
the angle between the TV and the stand at 30° or less, then fully
insert the stand column into the column socket on the stand.
5 Adjust the stand angle until it is at a 90° angle to the TV.
6 Move the stand gently until the locators on the stand column
align with the locating grooves on the stand, then use four
screws (provided) to secure the stand to the column.
To remove the stand, loosen the four screws.
Column socket
Long
Short
Stand
Short
Long
Stand
Table edge
Locating
grooves
Four screws