14
6 Press
to highlight Air/Cable, then press
or Cable, depending on the type of antenna connection you
have.
7 Press
to highlight Auto Scan, then press ENTER or to
automatically scan for available channels.
Auto Scan may take a while to complete. A progress report is
displayed while your TV is scanning for available channels. You
can press MENU to exit Auto Scan prior to completion, but you
will need to run Auto Scan later to complete the process.
Auto Scan creates a list of available/receivable channels for the
selected signal input.
Understanding the basics
Turning your TV on or off
To turn your TV on or off (standby mode):
1 Plug the power cord into an AC power outlet.
2 Press
(power). Your TV turns on.
3 Press
again to turn off your TV. When you turn off your TV, it
goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving power. To
completely disconnect power, unplug the power cord.
Note: If your TV does not receive an input signal for several minutes, it
automatically goes into standby mode.
or to select Air
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press the INPUT key on the remote, or the
2 Press
On-screen menu overview
Picture menu
Audio menu
Understanding the basics
INPUT button on the TV. The INPUT SOURCE menu opens.
or to highlight the video source, then press ENTER.
You can also select the input source using the following remote
control buttons:
• COMP—Press once to select Component1. Press twice to select
Component2.
• HDMI–Press once to select HDMI1. Press twice to select HDMI2.
Press three times to select HDMI3.
• VIDEO—Press once to select AV1. Press twice to select AV2.
Press three times to select S-Video.
• TV—Press to select TV.