Aiming The Remote Control; Turning On Your Tv For The First Time; Understanding The Basics; Turning Your Tv On Or Off - Dynex DX-46L260A12 User Manual

16
DX-46L260A12
3 Replace the battery cover.
Cautions
• Batteries should not be exposed to excessive
heat, such as sunshine, heat registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.

Aiming the remote control

To aim the remote control:
• Point the remote control towards the remote sensor on the
front of your TV.
Turning on your TV for the first
time
The first time you turn on your TV, the Setup Wizard opens. The Setup
Wizard guides you through setting up basic settings including the menu
language, picture mode, TV signal source, and the channel list.
To set up your TV:
1 Make sure that you have:
• Installed the remote control batteries. (See page 15 for
details).
• Connected an antenna, cable TV, or satellite TV. (See page 8
or 10 for details.)
• Connected the power cord. (See page 7 for details.)
2 Press (power) to turn on your TV. The Choose your menu
Language screen opens.
Choose your menu Language
English
Français
Español
Select
3 Press or to highlight the language you want, then press
ENTER. The Choose your Picture Mode screen opens.
Choose your Picture Mode
Home Mode
Retail Mode
Select
Setup Wizard
Next
Setup Wizard
Next
Back

Turning on your TV for the first time

4 Press or to highlight Home Mode or Retail Mode, then
press ENTER. The Choose your Tumer Mode screen opens.
Choose your Tuner Mode
Cable/Satellite Box
Select
5 Press or to highlight Antenna, Cable, or Cable/Satellite
Box (if your cable TV uses a box, select Cable/Satellite Box),
then press ENTER. If you chose Antenna or Cable, your TV
automatically starts scanning for channels available in your
viewing area. If you chose Cable/Satellite Box, your TV does
not need to scan for channels.
6 To watch TV, press INPUT, press or to highlight the video
input source for your TV in the INPUT SOURCE list, then press
ENTER.
• If your TV is connected to an antenna, cable TV (no box), or
cable or satellite TV box using a coaxial cable, select TV.
• If your TV is connected to a cable or satellite box using an
HDMI cable or HDMI cable with a DVI adapter, select HDMI 1
or HDMI 2.
• If your TV is connected to a cable or satellite box using a
component video cable, select Component.
• If your TV is connected to a cable or satellite box using a
composite video cable, select AV.

Understanding the basics

Turning your TV on or off

To turn your TV on or off:
1 Make sure that the power cord is connected to a power outlet.
2 Press (power) to turn on your TV. The power indicator LED
turns blue.
3 Press (power) again to turn off your TV. Your TV enters
Standby mode and the power indicator LED turns red.

Selecting the video input source

To select the video input source:
1 Turn on your TV, then press INPUT. The Input Source list opens.
Component
OK
2 Press or to highlight a video input source, then press
ENTER.
Setup Wizard
Antenna
Cable
Next
Back
Input
TV
AV
VGA
HDMI 1
HDMI 2
Selec t Exit