Warning Messages - Lexmark J110 Service Manual

4085-001

Warning Messages

As shown in each of the Status Screens, only one warning message
can be displayed at any one time. Once the current warning
condition is cleared, the printer automatically shows the next highest
priority warning message. If an event occurs which causes a higher
priority warning, the higher priority warning message replaces the
lower priority warning message.
Panel
Description
Message
Supplies One or more of the printer supply items
has either reached its life warning or is
exhausted and/or one of the paper
sources is low, empty, or missing.
Parallel The host interface from which the
USB<x> printer is currently drawing and
processing data.
Those messages which are not
designated by a <x> imply the active
host interface is a standard interface.
Those messages designated by <x>
indicate the active interface is
connected to the printer by PCI
connector x.
Those messages designated by
<x><y> indicate the active interface is
connected to the printer by a channel y
on PCI connector x, or if x=0 on the
standard network interface.
The copying message is shown when
the printer is drawing and processing
data originating from an OptraImage™
scanner connected to the printer by a
network adapter.
Note: There is no Copying host
interface. The associated network
interface which exists between the
printer and network adapter is used for
data transmission.
Available on Status
Screen
• Ready
• Hex Trace Ready
• Power Saver
• Busy
• Resolution Reduced
• Waiting
• Ready
• Hex Trace Ready
• Power Saver
• Busy
• Resolution Reduced
• Waiting
Diagnostic Information
2-13