Backup Roller Assembly Removal - Lexmark J110 Service Manual

4085-001

Backup Roller Assembly Removal

1. Remove all covers.
2. Remove carrier and belt. Refer to
Removal" on page
3. Remove pump housing, maintenance station, tank and
transport carrier motor. Refer to
Station/Ink Waste Tank/Transport Carrier Motor Removal" on
page 4-20.
4. Remove star wheel shaft. Refer to
Removal" on page
5. Remove the paper feed platen. Refer to
Assembly Removal" on page
6. Remove the backup roller springs.
7. Remove the index board assembly. Refer to
Assembly Removal" on page
8. Remove the encoder disk feed roller assembly. Refer to
"Encoder Disk Feed Roller Assembly Removal" on page
9. Remove the frame from the base. Refer to
Removal" on page
10. Disconnect all cable connectors from the engine board.
11. Remove, from the left side frame, two E-clips on the right side of
the backup roller assembly.
12. Move the paper feed frame and motor to the right and remove.
Refer to
Removal" on page
13. Move the backup roller assembly shaft to the left and remove it
from the right bushing.
14. Move the backup roller assembly to the right and out of the inner
deflector and remove.
Note: When removing the backup roller assembly, use care not to
damage the paper sensor flag.
4-14.
4-36.
4-27.
"Paper Feed Frame and Motor/Cam Shaft Assembly
4-40.
"Engine Board /Cover
"Pump Housing/Maintenance
"Star Wheel Shaft Assembly
"Paper Feed Platen
4-38.
"Index Card
4-22.
"Frame From Base
Repair Information
4-34.
4-47