Lexmark J110 Service Manual page 45

4085-001
Status Message
Programming System
Code
Resetting Printer
Restoring Factory
Defaults
Status
A representation of
the operator panel
when new code is
programmed in the
RIP code flash. This
message is shown
until the programming
is complete. When the
programming is
complete, the printer
performs a Power-On
Reset.
A representation of
the operator panel
during a Printer
Reset. The printer
resets with the Power-
On Reset defaults.
A representation of
the operator panel
after the operator has
initiated one or two
Factory Defaults
operations.
Action
No buttons are active
while this message is
displayed.
No buttons are active
while this message is
displayed.
No buttons are active
while this message is
displayed.
Diagnostic Information
2-23