Lexmark J110 Service Manual page 48

4085-001
Attendance Message
Change<input source>
<size>
Change<input source>
<type><size>
2-26
Service Manual
Description
A representation of
the operator panel
when the printer is
requesting the
operator to change
the media installed in
one of the input
sources. The input
source is displayed on
line 1 and could be
one of the following:
Tray 1, Tray 2, MP
Feeder.
If the requested type
matches the type that
is installed in the tray
and the type is one of
the custom types
which has not been
named, then only the
size is displayed. One
of the following sizes
is left-justified on line
2:
Letter, Legal, B2,
A4, Executive,
Universal, A5,
7 3/4 Envelope,
9 Envelope,
10 Envelope,
DL Envelope, C5
Envelope,
B5 Envelope,
Other Envelope
Action
Sources equipped with
both size-sensing and
media-present hardware:
Load the requested size
and/or paper type in the
source indicated in the
message. If media is
present in the source and
the sensed size is correct,
then the printer
automatically clears the
message and continue
the job.
If the source already
contains the correct size
and paper type, then
press Go. This situation
occurs when the user
changes the media in the
source, but forgets to
change the paper type
setting in the menus. Go
is ignored if the sensed
size is incorrect or media
is not present in the tray.
Note: The printer
assumes the user loaded
the correct paper type.
The new paper type,
paper size, and custom
string settings are stored
in NVRAM.