Queueing And Scheduling On Egress Queues - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 27
Configuring QoS
Queueing and Scheduling on Egress Queues
Figure 27-9
Note
If the expedite queue is enabled, SRR services it until it is empty before servicing the other three queues.
Figure 27-9
(DSCP or CoS value).
Determine egress queue
number and threshold
Queue the packet. Service
the queue according to
Rewrite DSCP and/or
Each port supports four egress queues, one of which (queue 1) can be the egress expedite queue. These
queues are assigned to a queue-set. All traffic exiting the switch flows through one of these four queues
and is subjected to a threshold based on the QoS label assigned to the packet.
OL-8915-01
shows the queueing and scheduling flowchart for egress ports.
Queueing and Scheduling Flowchart for Egress Ports
Start
Receive packet from
the internal ring.
Read QoS label
based on the label.
Yes
Are thresholds
being exceeded?
No
the SRR weights.
CoS value as
appropriate.
Send the packet
out the port.
Done
Drop packet.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Understanding QoS
27-17
Advertisement
Table of Contents
Troubleshooting
