Default Ethernet Vlan Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 10
Configuring VLANs
When you save VLAN and VTP information (including extended-range VLAN configuration
information) in the startup configuration file and reboot the switch, the switch configuration is selected
as follows:
•
•
•
If the VLAN database configuration is used at startup and the startup configuration file contains
Caution
extended-range VLAN configuration, this information is lost when the system boots up.
Default Ethernet VLAN Configuration
Table 10-2
The switch supports Ethernet interfaces exclusively. Because FDDI and Token Ring VLANs are not
Note
locally supported, you only configure FDDI and Token Ring media-specific characteristics for VTP
global advertisements to other switches.
Table 10-2
Parameter
VLAN ID
VLAN name
IEEE 802.10 SAID
MTU size
Translational bridge 1
Translational bridge 2
VLAN state
Remote SPAN
OL-8915-01
If the VTP mode is transparent in the startup configuration, and the VLAN database and the VTP
domain name from the VLAN database matches that in the startup configuration file, the VLAN
database is ignored (cleared), and the VTP and VLAN configurations in the startup configuration
file are used. The VLAN database revision number remains unchanged in the VLAN database.
If the VTP mode or domain name in the startup configuration does not match the VLAN database,
the domain name and VTP mode and configuration for the first 1005 VLANs use the VLAN
database information.
If VTP mode is server, the domain name and VLAN configuration for the first 1005 VLANs use the
VLAN database information
shows the default configuration for Ethernet VLANs.
Ethernet VLAN Defaults and Ranges
Default
1
VLANxxxx, where xxxx
represents four numeric digits
(including leading zeros) equal
to the VLAN ID number
100001 (100000 plus the
VLAN ID)
1500
0
0
active
disabled
Range
1 to 4094.
Note
No range
1 to 4294967294
1500 to 18190
0 to 1005
0 to 1005
active, suspend
enabled, disabled
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring Normal-Range VLANs
Extended-range VLANs (VLAN
IDs 1006 to 4094) are not saved in
the VLAN database.
10-7
Advertisement
Table of Contents
Troubleshooting
