Default Ieee 802.1X Authentication Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Chapter 7 Configuring IEEE 802.1x Port-Based Authentication

Default IEEE 802.1x Authentication Configuration

Table 7-2
Table 7-2
Feature
Switch IEEE 802.1x enable state
Per-port IEEE 802.1x enable state
AAA
RADIUS server
•
•
•
Host mode
Control direction
Periodic re-authentication
Number of seconds between
re-authentication attempts
Re-authentication number
Quiet period
Retransmission time
Maximum retransmission number
Client timeout period
Authentication server timeout period
Guest VLAN
Inaccessible authentication bypass
Restricted VLAN
OL-8915-01
shows the default IEEE 802.1x authentication configuration.

Default IEEE 802.1x Authentication Configuration

IP address
UDP authentication port
Key
Default Setting
Disabled.
Disabled (force-authorized).
The port sends and receives normal traffic without IEEE
802.1x-based authentication of the client.
Disabled.
None specified.
•
1812.
•
None specified.
•
Single-host mode.
Bidirectional control.
Disabled.
3600 seconds.
2 times (number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state).
60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before resending the request).
2 times (number of times that the switch will send an
EAP-request/identity frame before restarting the
authentication process).
30 seconds (when relaying a request from the
authentication server to the client, the amount of time the
switch waits for a response before resending the request
to the client.)
30 seconds (when relaying a response from the client to
the authentication server, the amount of time the switch
waits for a reply before resending the response to the
server. This setting is not configurable.)
None specified.
Disabled.
None specified.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring IEEE 802.1x Authentication
7-19