Extracting A Tar File; Displaying The Contents Of A File; Working With Configuration Files - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Working with Configuration Files

Extracting a tar File

To extract a tar file into a directory on the flash file system, use this privileged EXEC command:
archive tar /xtract source-url flash:/file-url [dir/file...]
For source-url, specify the source URL alias for the local file system. These options are supported:
•
•
•
•
The tar-filename.tar is the tar file from which to extract files.
For flash:/file-url [dir/file...], specify the location on the local flash file system into which the tar file is
extracted. Use the dir/file... option to specify an optional list of files or directories within the tar file to
be extracted. If none are specified, all files and directories are extracted.
This example shows how to extract the contents of a tar file located on the TFTP server at 172.20.10.30.
This command extracts just the new-configs directory into the root directory on the local flash file
system. The remaining files in the saved.tar file are ignored.
Switch# archive tar /xtract tftp:/172.20.10.30/saved.tar flash:/new-configs

Displaying the Contents of a File

To display the contents of any readable file, including a file on a remote file system, use the more [/ascii
| /binary | /ebcdic] file-url privileged EXEC command:.
This example shows how to display the contents of a configuration file on a TFTP server:
Switch# more tftp://serverA/hampton/savedconfig
!
! Saved configuration on server
!
version 11.3
service timestamps log datetime localtime
service linenumber
service udp-small-servers
service pt-vty-logging
!
<output truncated>
Working with Configuration Files
This section describes how to create, load, and maintain configuration files.
Configuration files contain commands entered to customize the function of the Cisco IOS software. A
way to create a basic configuration file is to use the setup program or to enter the setup privileged EXEC
command. For more information, see
Gateway."
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
B-8
Appendix B
For the local flash file system, the syntax is
flash:
For the FTP, the syntax is
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
For the RCP, the syntax is
rcp:[[//username@location]/directory]/tar-filename.tar
For the TFTP, the syntax is
tftp:[[//location]/directory]/tar-filename.tar
Working with the Cisco IOS File System, Configuration Files, and Software Images
Chapter 3, "Assigning the Switch IP Address and Default
OL-8915-01