Configuring Ethernet Interfaces; Default Ethernet Interface Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Configuring Ethernet Interfaces
This example shows how to delete the interface-range macro enet_list and to verify that it was deleted.
Switch# configure terminal
Switch(config)# no define interface-range enet_list
Switch(config)# end
Switch# show run | include define
Switch#
Configuring Ethernet Interfaces
These sections contain this configuration information:
•
•
•
•
•
Default Ethernet Interface Configuration
Table 8-1
listed in the table, see
see
Table 8-1
Feature
Allowed VLAN range
Default VLAN (for access ports)
Native VLAN (for IEEE 802.1Q
trunks)
VLAN trunking
Port enable state
Port description
Speed
Duplex mode
Flow control
EtherChannel (PAgP)
Port blocking (unknown multicast
and unknown unicast traffic)
Broadcast, multicast, and unicast
storm control
Protected port
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
8-10
Default Ethernet Interface Configuration, page 8-10
Configuring Interface Speed and Duplex Mode, page 8-11
Configuring IEEE 802.3x Flow Control, page 8-15
Configuring Auto-MDIX on an Interface, page 8-16
Adding a Description for an Interface, page 8-17
shows the Ethernet interface default configuration. For more details on the VLAN parameters
Chapter 10, "Configuring VLANs."
Chapter 19, "Configuring Port-Based Traffic Control."
Default Layer 2 Ethernet Interface Configuration
Chapter 8
For details on controlling traffic to the port,
Default Setting
VLANs 1 to 4094.
VLAN 1.
VLAN 1.
Switchport mode dynamic auto (supports DTP).
All ports are enabled.
None defined.
Autonegotiate.
Autonegotiate.
Flow control is set to receive: off. It is always off for sent packets.
Disabled on all Ethernet ports. See
EtherChannels and Layer 2 Trunk Failover."
Disabled (not blocked). See the
19-6.
Disabled. See the
"Default Storm Control Configuration" section
on page
19-3.
Disabled. See the
"Configuring Protected Ports" section on
page
19-5.
Configuring Interface Characteristics
Chapter 28, "Configuring
"Configuring Port Blocking"
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
