Modifying The Startup Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Chapter 3 Assigning the Switch IP Address and Default Gateway
!
interface GigabitEthernet0/24
switchport access vlan 2
switchport trunk native vlan 2
!
interface Vlan1
no ip 2.2.2.122 255.255.255.0
no ip route-cache
!
ip http server
snmp-server community public RO
!
control-plane
!
To store the configuration or changes you have made to your startup configuration in flash memory, enter
this privileged EXEC command:
Switch# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
This command saves the configuration settings that you made. If you fail to do this, your configuration
will be lost the next time you reload the system. To display information stored in the NVRAM section
of flash memory, use the show startup-config or more startup-config privileged EXEC command.
For more information about alternative locations from which to copy the configuration file, see
Appendix B, "Working with the Cisco IOS File System, Configuration Files, and Software Images."

Modifying the Startup Configuration

These sections describe how to modify the switch startup configuration:
•
•
•
•
•
See also
Images,"
OL-8915-01
Default Boot Configuration, page 3-14
Automatically Downloading a Configuration File, page 3-14
Booting Manually, page 3-15
Booting a Specific Software Image, page 3-16
Controlling Environment Variables, page 3-16
Appendix B, "Working with the Cisco IOS File System, Configuration Files, and Software
for information about switch configuration files.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Modifying the Startup Configuration
3-13