Booting Manually - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Chapter 3 Assigning the Switch IP Address and Default Gateway
Command
Step 4 show boot
Step 5 copy running-config startup-config
To return to the default setting, use the no boot config-file global configuration command.

Booting Manually

By default, the switch automatically boots; however, you can configure it to manually boot.
Beginning in privileged EXEC mode, follow these steps to configure the switch to manually boot during
the next boot cycle:
Command
Step 1 configure terminal
Step 2
boot manual
Step 3 end
Step 4 show boot
Step 5
copy running-config startup-config
To disable manual booting, use the no boot manual global configuration command.
OL-8915-01
Purpose
Verify your entries.
The boot config-file global configuration command changes the
setting of the CONFIG_FILE environment variable.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable the switch to manually boot during the next boot cycle.
Return to privileged EXEC mode.
Verify your entries.
The boot manual global command changes the setting of the
MANUAL_BOOT environment variable.
The next time you reboot the system, the switch is in boot loader
mode, shown by the switch: prompt. To boot the system, use the
boot filesystem:/file-url boot loader command.
For filesystem:, use flash: for the system board flash device.
•
For file-url, specify the path (directory) and the name of the
•
bootable image.
Filenames and directory names are case sensitive.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Modifying the Startup Configuration
3-15