Removing A Remote Supervisor Adapter Ii Slimline; Installing A Remote Supervisor Adapter Ii Slimline - IBM System x3250 4364 Problem Determination And Service Manual

Hide thumbs Also See for System x3250 4364:
Table of Contents

Advertisement

11. Turn on all attached devices and the server.

Removing a Remote Supervisor Adapter II SlimLine

To remove a Remote Supervisor Adapter II SlimLine from the server, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Grasp the riser-card assembly at the rear edge and lift to remove it from the
4. Spread the mounting bracket retention latches as you lift the Remote Supervisor

Installing a Remote Supervisor Adapter II SlimLine

See the illustration in "System-board optional device connectors" on page 10 for the
location of the dedicated connector for the Remote Supervisor Adapter II SlimLine.
After the Remote Supervisor Adapter II SlimLine is installed, the
systems-management port on the rear of the server is active.
Notes:
1. When you start the server for the first time after you install a Remote Supervisor
2. Earlier versions of the Remote Supervisor Adapter II SlimLine might not work in
on page 25.
external cables; then, remove the cover.
server. Set the riser-card assembly aside on a flat, static-protective surface.
Mounting bracket
retention latch
Mounting bracket
Adapter II SlimLine, to disconnect it from the system board; then, lift it out of the
server.
Adapter II SlimLine, the startup process will take several minutes longer than a
typical startup.
this server. See http://www.ibm.com/servers/eserver/serverproven/compat/us/ for
the supported Remote Supervisor Adapter II SlimLine.
Remote Supervisor Adapter II SlimLine
Rear of system
Chapter 4. Removing and replacing server components
Mounting bracket
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3250 4365System x32504366

Table of Contents