Installing The Remote Supervisor Adapter Ii Slimline - IBM x3550 Problem Determination And Service Manual

4. Spread the card retainers as you lift the Remote Supervisor Adapter II SlimLine

Installing the Remote Supervisor Adapter II SlimLine

To install the Remote Supervisor Adapter II SlimLine assembly, complete the
following steps. Refer to the graphics in "Removing the Remote Supervisor Adapter
II SlimLine" on page 57:
1. Position the Remote Supervisor Adapter II SlimLine card so that the keys on the
2. Insert the card into the rear retainer bracket; then, press the card into the
3. Replace the PCI riser-card assembly and adapter (if present).
4. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
5. Install the cover (see "Installing the cover" on page 42).
6. Slide the server into the rack.
58
IBM System x3550 Type 7978 and 1913: Problem Determination and Service Guide
Pins
Remote Supervisor
Adapter II SlimLine
Connector
Pins
Mounting bracket
Mounting bracket
retention latches
card to disconnect it from the system board, then lift it out of the server.
connector align correctly with the connector on the system board.
connector and make sure that all support posts and retainers secure the card in
place.
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Mounting bracket