Ipmitool Command For Dynamic Entry On The Dns Server When Drac Is Not Present - Dell External OEMR 1435 User Manual

Default Subcommand
If a subcommand is not specified, this command functions the same as sel
info.
Options for
sensor
• list — Displays the complete list of sensors and thresholds in a wide
table format.
• get < id > ... [ <id> ] — Displays information for sensors specified
by ID number.
• thresh < id > < threshold > < setting > — Allows you to set a
particular sensor threshold value. The sensor is specified by name. Valid
thresholds are:
• unr — Upper Non-Recoverable
• ucr — Upper Critical
• unc — Upper Non-Critical
• lnc — Lower Non-Critical
• lcr — Lower Critical
• lnr — Lower Non-Recoverable
Default Subcommand
If a subcommand is not specified, this command acts the same as sensor list.
IPMItool Command for Dynamic Entry on the DNS Server When DRAC is
Not Present
To create a dynamic entry on the DNS server when DRAC is not present, use
the following command:
ipmitool raw 0x18 0x58 0xe4 0x15
NOTE:
You must enter a 21-byte hexadecimal number (a 8-byte input for the
PowerEdge 1435SC) for the DHCP name. If the DHCP name is less than 21 bytes (8
bytes for PowerEdge SC1435), pad the end with zeroes.
96
Using the BMC Management Utility