Dell External OEMR 1435 User Manual page 35

Table 2-1. Remote Access Configuration Utility (continued)
Option
DNS Server 2
Register RAC Name
Register RAC Name
Domain Name from DHCP Turns the domain name on or off.
Domain Name
Virtual Media
Configuration
Virtual Media
Virtual Flash
LAN User Configuration
Account Access
Account Privilege
Account User Name
Description
This field is read-only when DNS Servers from
DHCP is set to on.
Enter the IP Address of DNS Server 2
The following IPv4 rules apply:
• IP addresses cannot be 127.xxx.xxx.xxx, where xxx is
between 0-255.
• The first octet must be between 1-223 (i.e.
143.xxx.xxx.xxx)
• The last octet must not be 0 or 255
(i.e. xxx.xxx.xxx.0 or xxx.xxx.xxx.255)
on = You may enter the Current DNS RAC Name.
This field is read-only when Register RAC Name is
set to off.
Enter the Current DNS RAC Name using 1-32 alpha-
numerics, spaces, and symbols. Press <Enter> to save
the value. Press <Esc> to exit the field without saving.
This field is read-only when DNS Servers from
DHCP is set to on.
Enter the Domain Name using 1-64 alpha-numerics,
spaces, and symbols. Press <Enter> to save the value.
Press <Esc> to exit the field without saving.
NOTE:
This option is available only on systems with a
DRAC installed.
Attaches or detaches a virtual media drive.
Enables or disables virtual flash memory.
Enables setting the user name, user password, user
privilege, and enables user access for user ID=2.
Enables or disables account privileges.
Sets the account to:
Admin, User, Operator, or No Access
Sets the account user name.
Configuring Your Managed System
35