Entering The Remote Access Configuration Utility; Remote Access Configuration Utility Options - Dell External OEMR 1435 User Manual

Figure 2-1. Remote Access Configuration Utility

Entering the Remote Access Configuration Utility

1 Turn on or restart your system.
2 Press <Ctrl-E> when prompted after POST.
If your operating system begins to load before you press <Crtl-E>,
allow the system to finish booting, and then restart your system and try
again.

Remote Access Configuration Utility Options

Table 2-1 lists the Remote Access Configuration Utility options and shows
how to configure the BMC on a managed system. After entering all settings,
press <Esc> and select one of the following:
• Save Changes and Exit—Keep all entries made in the Remote Access
Configuration Utility.
• Discard Changes and Exit—Undo all entries made in the Remote Access
Configuration Utility.
• Return to Setup—Continue using the Remote Access Configuration Utility.
30
Configuring Your Managed System