Restart Wms On Local Controllers; Configure Arubaos Cli When Not Offloading Wms; Copy And Paste To Enable Proper Traps With The Arubaos Cli - Dell PowerConnect W-Airwave Manual

To disable debugging, SSH into the controller, enter "enable" mode, and issue the following commands:
(Controller-Name) # show running-config | include logging level debugging
If there is output, then use the following commands to remove the debugging:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # no logging level debugging <module from above>
(Controller-Name) (config) # write mem

Restart WMS on Local Controllers

To ensure local controllers are populating rogue information properly, use SSH to access the command-line
interface of each local controller, enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # process restart wms
After executing the restart WMS command in ArubaOS, you will need to wait until the next Rogue Poll Period
on the AirWave and execute a Poll Now operation for each local controller on the APs/Devices > List page before
rogue devices begin to appear in AirWave.

Configure ArubaOS CLI when not Offloading WMS

To ensure proper event correlation for IDS events when WMS is not offloaded to AirWave, access the command
line interface of each controller (master and local), enter "enable" mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # ids management-profile
(Controller-Name) (config) # ids general-profile <name>
(Controller-Name) (config) # ids-events logs-and-traps
(Controller-Name) (config) # write mem

Copy and Paste to Enable Proper Traps with the ArubaOS CLI

To ensure the proper traps are configured on Dell PowerConnect W-Series controllers, copy and paste the
following command in config mode:
snmp-server trap enable wlsxNUserAuthenticationFailed
snmp-server trap enable wlsxUserAuthenticationFailed
snmp-server trap enable wlsxNAuthServerReqTimedOut
snmp-server trap enable wlsxSignatureMatchAP
snmp-server trap enable wlsxSignatureMatchSta
snmp-server trap enable wlsxSignAPNetstumbler
snmp-server trap enable wlsxSignStaNetstumbler
snmp-server trap enable wlsxSignAPAsleap
snmp-server trap enable wlsxSignStaAsleap
snmp-server trap enable wlsxSignAPAirjack
snmp-server trap enable wlsxSignStaAirjack
snmp-server trap enable wlsxSignAPNullProbeResp
snmp-server trap enable wlsxSignStaNullProbeResp
snmp-server trap enable wlsxSignAPDeauthBcast
snmp-server trap enable wlsxSignStaDeauthBcastwlsxChannelFrameErrorRateExceeded
snmp-server trap enable wlsxChannelFrameFragmentationRateExceeded
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide ArubaOS and AirWave CLI Commands | 33