Table 17 Diagnostic Mode Event Codes - Tandberg Data DLT-V4 Product Manual

Table 17 Diagnostic Mode
Event Codes
DLT-V4 Product Manual
character is either a hex E (error) or a B (bug check). You can look up the
remaining seven characters in the error/bug check definition tables.
When you display the last (eighth) detailed error code digit, the next
button press returns the tape drive to normal operation. All indications
are a four bit hex value.
During any time in this procedure, the tape drive returns to normal
operation if you perform no scroll action within 15 seconds.
LED Fault Code
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Failure
SCSI Event
General Error
Software Bug Check
Permanent Write Error
Permanent Read Error
Servo Fault
Code Update was Completed
Illegal Format
Invalid Cartridge
Calibration Failure
Cleaning was Completed
Directory Read or Write Failed
Diagnostic Failed
POST Failure
Reserved
Chapter 4 Using Your Tape Drive
Diagnostic Mode Event Codes
53