Chapter 2 Installing The Tape Drive; Preparing To Install The Tape Drive; Before You Start; Scsi Bus Requirements - Tandberg Data DLT-V4 Product Manual

Preparing to Install the Tape Drive

Before You Start

SCSI Bus Requirements

DLT-V4 Product Manual Guide
Installing the Tape Drive
2
This chapter explains how to configure and install the tape drive.
Configuration and installation are not difficult and require only that you
follow the instructions presented in this chapter.
This section helps you prepare to install the DLT-V4 tape drive (tabletop
or internal).
Installing the DLT-V4 SCSI tabletop tape drive requires no special tools.
2
For the SCSI interface, you will need a ballpoint pen to change the SCSI
ID switch on the rear panel of the tape drive.
If you are installing a DLT-V4 SATA internal tape drive, see
Internal SATA Tape Drive
V4 internal tape drive requires only the usual tools needed to install an
internal tape drive in the computer you have chosen to house the tape
drive (for example, a screwdriver and some ESD protection).
The DLT-V4 SCSI interface tape drive (tabletop and internal) incorporates
2
a wide Ultra160 low-voltage differential (LVD) small computer system
on page 25 for instructions. Installing the DLT-
Chapter 2
2
Installing the
4