Tandberg Data DLT-V4 Product Manual page 46

DLT-V4 Product Manual
At the "Install From Disk" view, click
7
folder where you saved the driver files. Select the "QntmDLT.inf" file
in that folder, and click
At the "Install From Disk" view, verify that the drive letter and path
8
shown are correct. Then click
In the next view, highlight the Tandberg Data DLT-V4 tape drive, and
9
then click . The "Start Device Driver Installation" view is displayed.
Next
Click to install the driver.
10 Next
If the Wizard should indicate that a driver already exists on
Note:
the system and prompts you for a selection, select
the Windows 2000 Setup window is displayed, verify the
correct path to the driver, and then click
The next view is "Completing the Upgrade Device Driver Wizard".
11
Click . You may be prompted to reboot your system.
Finish
The DLT-V4 device driver is installed.
Chapter 2 Installing the Tape Drive
Installing the Device Drivers
Browse ...
.
Open
.
OK
, and then locate the
. When
New
.
Continue
34