Completing The Tabletop Scsi Tape Drive Installation - Tandberg Data DLT-V4 Product Manual

Completing the Tabletop
SCSI Tape Drive
Installation
DLT-V4 Product Manual
Secure the SCSI cable connectors by tightening the screws until snug.
1
2
If the SCSI cable does not fit the connector on the SCSI
Note:
host adapter, you either have an incompatible SCSI host
adapter or you need to purchase a cable adapter. Contact
the sales representative or the SCSI host adapter
manufacturer for information.
Make sure the power switch on the rear panel of the tape drive is in
2
the OFF position (tabletop model only). Attach the female connector
on the power cable to the power connector on the rear panel of the
tape drive, as shown in
Connect the power cables to the server or workstation and all
3
peripheral devices.
Plug the power cable into a nearby power outlet.
4
Power on the tape drive and any other devices you powered off
5
earlier.
Power on the server or workstation and allow its operating system to
6
start.
Check the tape drive to make sure it is working properly. See
7
On Self-Test (POST) Indicator Activity
tape drive's self-test and initialization features.
Chapter 2 Installing the Tape Drive
Installing the Tabletop SCSI Tape Drive
figure 5.
on page 47 to learn about the
Power-
13